Sentence examples for almost at the same position from inspiring English sources

results show that the absorption peak of the carbonyl group of the PMMA in the blends stays almost at the same position as in the pure component.

This is because two reflectance peaks from quartz are almost at the same position as those of silicate melt with high SiO2 content, which is in chemical equilibrium with the host quartz.

Furthermore, our algorithm was tested on two scans acquired from the same scene at different time instants with some changes as shown in Figure 8, where we acquired two scans almost at the same position after some people moved.

This performance variance can be explained from that the RGB-D data has higher resolution (1280×1024) [85] than depth data (176×144) [83]; hence, the keypoints are more probable to be positioned almost at the same position and the angle between three random keypoints does not change much.

Also, the adenosyl moiety of bio-5'-AMP and ADP interact almost at the same position.

The RBC is usually almost at the same position as RPE, but in cases of RPE detachment it is often not (i.e., Fig. 10 below).

The maximum peaks are almost at the same positions both in UV vis and PL spectra indicated that the grafted pyrazoline on calix[4]arene by chemical bond can help to disperse emitting pyrazoline chromophores in host material of calix[4]arene and tend to reduce the interaction of each pyrazoline molecule.

Comparing with previous work of ZnO nanowires [16], Huang et al. reported that two peaks of E2 mode taken respectively from tips and roots of ZnO nanowires/belts arrays were almost centered at the same position of 436 cm−1.

The 650- to 700-nm peaks for the three samples appear at almost the same position (at about 667 nm), while the 500- to 650-nm ones redshift slightly with respect to that of the incident light source.

The water oil front arrived at almost the same position and the differential pressure curves are approximately consistent at the same time.

To ensure the tests were made at almost the same position before and after bleaching, points with a maximum load of 9000 μN were marked on the samples (Fig. 2).