Sentence examples for alloy tests from inspiring English sources

The models were calibrated with the use of existing experimental data, obtained from aircraft aluminium alloy tests.

A very good combination of strength and ductility was observed for the alloy tested in FS processed condition.

Water spray cooling, however, is found to be feasible only for Ti alloy test pieces and destructions of C/SiC test pieces are observed after the experiment.

The results showed that before heating some micro-cracks were present in sealed anodic films on the aluminum alloy tested.

The results have been compared with those corresponding to the same alloy tested quasi-statically under equivalent conditions.

In this study, fatigue crack growth microstructural mechanisms were established for bulk cold-spray processed 6061 aluminum alloy tested in laboratory air at room temperature.

At 700 °C, the amount of dissolution was reduced when a Mo capsule was used instead of a V alloy test capsule.

The local conditions favoring such a damage mode are analyzed in this paper considering the high strength cast and wrought Udimet™ 720Li alloy tested at room temperature.

The 7075-T6511 alloy tested under both a spectrum with almost no compressive loads and a filtered spectrum derived from this, showed no indication of being bimodal.

The cyclic deformation behaviour of 20% prior cold worked (PCW) material was compared with the LCF response of solution annealed (SA) alloy tested under similar conditions.

The elastic stiffnesses predicted numerically and analytically are then compared with experimental data on a Ni-base DS alloy tested uniaxially along arbitrary orientations.