The phrase "allowed transmit" is not correct in written English.
It seems to be missing a preposition or an article, such as "to" or "to be able to."
Example: "You are allowed to transmit the information once you receive approval."
Alternatives: "permitted to transmit" or "authorized to transmit."
In the examples of this subsection, it is assumed that all the relays have the same maximal allowed transmit power.
Instead, they are charged either for the received signal to interference and noise power ratio (SINR) or for their allowed transmit power.
where ( overline{eta_{mathrm{SE}}} ) is the minimum spectral efficiency requirement, ( {displaystyle {overline{P}}_{mathrm{B}}} ) and ( {displaystyle {overline{P}}_{{displaystyle {mathrm{R}}_{mathrm{k}}}}} ) are the maximum allowed transmit powers of the BS and the RSs, respectively.
Very low allowed transmit power makes receiver sensitivity highly important metric for HBC receivers in order to enable that the wake-up range spans over the entire human body.
For half-duplex relaying, it is obvious that the system performance is optimized when the source and the relay use the maximum allowed transmit power, so we focus on power control for full-duplex relaying.
This leads to a fixed transmission rate r in Assumption 2. For a BLE transmitter, according to the current specification [3], the power of output radio signal should range from −20 to +10 dBm and the sensitivity level of the BLE receiver should be below −70 dBm, which translates to the limits p min and p max on the allowed transmit power.
As we see from Figure12, this type of predistortion allows transmitting at saturation without the warping effect.
The high infrared (IR) transparency of fibers on the basis of the ChG allows transmitting high-power IR light.
Furthermore, full-duplex (FD) mode was evaluated, in which it allows transmitting and receiving signals at the same frequency band at the same time slot.
One particular approach is a cooperative relay scheme that allows transmitting duplicate signals via multiple relay stations and then, combining them constructively in the receiver [15].
Another sub-optimal design of the max−d min precoder, which allows transmitting more than two independent datastreams and increasing the order of the modulations, is presented in [14].
