The phrase "allowed area" is correct and usable in written English.
It can be used to refer to a designated space where certain activities or behaviors are permitted.
Example: "Please ensure that all activities are conducted within the allowed area to maintain safety and compliance."
Alternatives: "permitted zone" or "designated area".
One way to guarantee that robust control is achieved is to establish robustness barriers in the frequency domain, which the controlled system should not overcome, guaranteeing robustness when working in an allowed area.
This allowed area measurements to be expressed in calibrated square micrometer values; pixel values were displayed at the bottom of the screen.
Although speculative, this model readily fulfills geometric constraints (>70% of residues occur in the allowed areas of the Ramachandran plot and >90% in the generously allowed area) and reasonably accounts for both the associated cellulose-binding and carbohydrate-binding properties previously reported for CBEL [ 18, 41].
A global fit combining SK data with the solar neutrino interaction rates measured by Homestake, SNO, Gallex/GNO and SAGE prefers a single allowed area, the Large Mixing Angle solution, at the 98.9% confidence level.
The task analysis procedure allowed areas of usability improvement to be identified and then addressed with alternate interface prototypes.
Individuals were considered non-exposed if they did not spend time at smoking allowed areas or if they spent time there but reported no one was smoking.
Keenan is a Rappaport/Boston Urban Scholar, a fellowship that allows area lawmakers and policymakers to study at HKS.
Using $3.4 million in federal money from the July 2008 Housing and Economic Recovery Act, city officials have begun a program to allow area nonprofit organizations to buy, repair and resell foreclosed homes.
6. Managerial commitment is assured by allowing area or divisional managers to choose whether to join the program or to create their own mechanisms.
In the following analysis we will not make such an assumption and will allow area and material properties to vary with the position along the vessel.
Vacuum again to remove excess water, and allow area to dry.
