The phrase "allowable values of the" is correct and usable in written English.
It can be used in contexts where you are discussing permissible options or limits within a certain framework, such as programming, data entry, or specifications.
Example: "Please refer to the documentation for the allowable values of the input parameters."
Alternatives: "permissible values of the" or "acceptable values of the".
The stresses are far below the allowable values of the ASME code.
Second, we have calculated the maximum allowable values of the transmit power for small cells which work in flexible duplexing mode and which are deployed among macro base stations.
The functions N w (x SSB ) represent the set of allowable values of the pair x SSB, N w for each extension change data point Δ x(F), and are plotted as colored curves in Figure 3 figure supplement 1 for selected data points from Figure 3A.
It was found that the flexural ductility design of SSTT-confined HSC columns can be simplified by controlling the maximum allowable values of these parameters.
The results show that the compressor blisk has a reliability degree of 0.9984 when the allowable value of the compressor blisk radial deformation is 1.60×10−3 m.
Three main ideas were the pillars of the development activities: the reduction of the geometrical filament size down to 2 μm, the use of CuMn resistive barriers to reduce the inter filament coupling currents, and the reduction to the minimum allowable value of the twist pitch.
We focus on the influence of the elasticity of the trunk joints on the possibility of the transition and the allowable value of the transition velocity.
An example will help us understand this phenomenon: imagine a big room with a door; the maximum allowable value of the entering people in unit time is N.
It can be seen that the system pressure is controlled and limited to the maximum allowable value of the accumulator inlet absolute pressure (i.e. 21 MPa as listed in Table 1).
When the residual maximum flexural crack width is set at 0.4 mm, the allowable value of the maximum flexural crack width at the peak deformation angle is 0.8 mm.
It can be seen in Table 4 that in all fixation types the occurring tension pulled the screws and exceeded the allowable values of 1.2 MPa at least on one of the studied screw surfaces.
