The phrase "allowable minimum" is correct and usable in written English.
It can be used in contexts where you are referring to the least amount or level that is permitted or acceptable in a given situation.
Example: "The allowable minimum for the project budget is set at $10,000 to ensure adequate resources are allocated."
Alternatives: "permissible minimum" or "acceptable minimum".
However, to avoid the ill-conditioning of numerical calculation, a is not allowed to be zero just as there is a limitation of the allowable minimum of 0.1 for the meridional eccentricity ε in the embedded M C model [18].
But the Real Estate Board's zoning consultant, H. Thomas O'Hara, calculated that on a 20,000-square-foot merged zoning lot, half of it occupied by an existing building, the setback requirements would yield a tower with floors of 6,450 square feet -- or 32percentt of the lot -- which is below the allowable minimum of 33percentt.
Moreover, the number of slopes and the allowable minimum thickness influence the results.
(2) Degrade ongoing adaptive call(s) to the allowable minimum basic bandwidth unit (bbu), if necessary, to admit an incoming call.
The focal lengths of the cameras were set to the allowable minimum value (18 mm) in order to capture the whole structure in the yard.
This means that to have an optimal panel, each cell should have the allowable minimum cross section (highest number of cells) and maximum allowable length.
These are evaluation of maximum allowable stress, minimum required fracture toughness, and maximum tolerable defect size.
The three alternative applications for the crack-tip opening displacement design curve explained in this chapter include maximum allowable strain, minimum required fracture toughness, and maximum allowable flaw size.
Constraints of allowable stress, minimum size and buckling of members in the absence of allowable displacement constraint are the most important factors in optimization of the cross-sectional area of structural elements.
There are three alternative applications for the CTOD Design Curve, which are also explained in this chapter, which include maximum allowable strain, minimum required fracture toughness, and maximum allowable flaw size.
The technique allows a designer to, for example, prescribe a minimum allowable length scale of structural members (solid phase) as well as the minimum allowable length scale on holes (void phase).
