The phrase "allowable material" is correct and usable in written English.
It can be used in contexts where you are discussing materials that are permitted or acceptable for a specific purpose, such as in regulations, guidelines, or specifications.
Example: "The construction project must adhere to the standards set forth, including the use of only allowable material for safety compliance."
Alternatives: "permissible material" or "acceptable material".
The objective is to minimize the generalized compliance within allowable material volume.
The thermal hydraulic analyses of each module indicate full compliance with the allowable material temperatures.
Without displacement sensitivities, the AVC algorithm iteratively adjusts allowable material usage based on the difference between the actual displacement, and the allowable displacement limit.
The peak stress was reduced below the allowable material strength margin with increasing the fillet radius of the round and decreasing the depth of the liquid gather groove.
Shaft design involves consideration of the layout of features and components to be mounted on the shaft, specific dimensions and allowable tolerances, materials, deflection, frequency response, life, and manufacturing constraints.
The characterization and application of material allowable, examining and statistical analysis ways of test data are described, and the determining methods for design allowable values of static strength, fatigue strength, damage tolerance and repair are also analyzed.
The model test shows that the maximum stress in the joint is less than the material allowable stress and the maximal stress induced from the secondary moment accounts for about 30% of the total stress.
Stresses at general part of the VV body are lower than the structure material allowable stress (117 MPa) and this analysis show that the maximum stresses occur near the gravity support, and is about 98 MPa.
Methodologies for treating such damage in establishing material allowables are considered.
While the values shown are nominal, not statistically minimum values, these are considered material allowables for the sake of illustration in this chapter.
In numerical analysis the failure of engineering materials is controlled through specifying yield envelopes (or surfaces) that bound the allowable stress in the material.
