The phrase "allow the sample to" is correct and usable in written English.
It can be used when giving instructions or describing a process that involves permitting a sample to undergo a specific action or condition.
Example: "In the experiment, allow the sample to sit for 30 minutes before measuring its temperature."
Alternatives: "permit the sample to" or "let the sample".
Rinse this material into filter paper placed within a funnel, allow the sample to drain, and then air dry in place safe from contamination and breezes.
These densely packed arrays, which have the potential to be 100 times more sensitive than existing antibody sensors, also featured nanoscale channels that allow the sample to flow easily through the entire sensor.
Pressurised nitrogen was applied to the sample and left to "soak" to allow the sample to equalise to the test pore pressure and temperature.
Our form suggests that participants who wish to discontinue participation will be offered various levels of withdrawal, but some studies may choose not to offer any options other than destroying the remaining sample, or may not have maintained a link that would allow the sample to be identified.
To both preserve the integrity of genomic DNA for the use of fingerprinting and allow the sample to be further processed safely outside a CL3 laboratory, it is recommended to complete DNA extractions with CTAB as per the standard protocol to confirm the complete inactivation of M. tuberculosis.
For each test the panellist had to take a 5 ml spoonful of each sample, place in their mouth on their tongue, remove the spoon, allow the sample to coat the roof of their mouth, hold in the mouth for a minimum of 5 s before swallowing, then cleanse their palate with water before tasting the next sample.
A good rule is to make the grid about three times the number of samples, this is to allow the samples to spread around.
Allow the samples to stand for a few hours at room temperature before refrigerating.
Pressure was applied to allow the samples to flow through the silica gel column.
We allow the samples to dry to touch (approximately 2 wk).
Preliminary reports revealed that a time of 10 min ensured sufficient relaxation to allow the samples to fully equilibrate [ 31].
