The phrase "aggregates thickness" is correct and usable in written English.
It can be used in contexts related to construction, materials science, or geology when discussing the measurement of thickness in aggregate materials.
Example: "The aggregates thickness in the concrete mix must be carefully measured to ensure structural integrity."
Alternatives: "thickness of aggregates" or "aggregate layer thickness".
For micrometastasis and ITCs analysis, we examined three serial sections, each 10 μm thick (with an aggregate thickness of 30 μm), from each of the paraffin blocks of the lymph nodes, which were used for CAM5.2 immunohistochemical examination as described below.
A maximum aggregate thickness of 600 metres (1,970 feet) occurs in Michigan, where one individual halite bed reaches a thickness of l65 metres (540 feet).
The two beds have a maximum aggregate thickness of about 98 feet (30 metres) and consist almost entirely of stream-laid detrital sediment.
This article provides an estimate of the aggregate thickness required for unpaved roads resting on c-φ soil.
Efficacy of the geotextiles has been elucidated in terms of the degree of improvement represented as reduction of aggregate thickness.
Utility of a single geotextile layer beneath the aggregate has also been investigated towards further reduction of the required aggregate thickness.
The Cenozoic rocks unconformably overlie the Deccan basalt and Mesozoic rocks with an aggregate thickness of around 300 m (Biswas 1992; Sarkar et al. 1996) and contain huge lignite deposits including those of Matanomadh.
It is imperative that if cohesion is considered as the sole strength criterion, it will provide lower bearing resistance, and hence, will overestimate the aggregate thickness required, which will eventually lead to undesirable increase in the overall project cost.
In this regard, this article reports the result of an attempt made to identify the diminution in the required aggregate thickness of the unpaved road when both the strength characteristics of the subgrade soil are taken into account.
Incorporating bearing capacity estimation of the c-φ soil, necessary expressions have been developed for estimating the required aggregate thickness as a function of the axle load, tire inflation pressure, cohesion and angle of internal friction of subgrade soil, angle of internal friction and load distribution angle of the aggregate.
