Sentence examples for after the coating process from inspiring English sources

After the coating process, all coated titanium plates were rinsed with deionized water and dried at room temperature.

After the coating process, the release rate of SB from the coated nanocomposites (Fig. 4b e) was significantly lower than the release rate of SB from the uncoated ones (Fig. 4a), with the amount of initial release reduced to approximately 6 17% after 60 min.

Both R a and R q values substantially dropped to lower values in all the coated formulations, implying that the coating polymer was deposited on the bead surface after the coating process.

The top of Figure 4a shows the resonant frequencies of the PA-MCL: νo, before the coating process and ν CPA-MCL) after the coating process for a deposition time t = 4 min. For this coated PA-MCL, the ratio ν CPA-MCLCL)/νo 2 is 0.9778.

TEM micrographs show an abundance of Al2O3 particles and amorphous BN appearing uniformly on the surface of the 3Y-TZP particles after the coating process.

A precise characterization using numerical simulations allows the determination of residual errors in the structure, which can appear during or after the coating process.

The creep behavior of uncoated material was studied after various heat treatments to simulate the coating process and typical secondary heat treatments.

After closing of the aperture (1900 s) the coating process is finished and the base level of the experiment is almost reached.

(a) (Top) Resonant frequencies for the PA-MCL: νo representing the resonant frequency before the coating process and ν CPA-MCL) representing the resonant frequency after the Co coating process with deposition time t = 4 min. ν CPA-MCLCL)/νo 2 = 0.9778.

Q: Could you describe the coating process?

The objectives of this work are to optimize the coating process of Fe3O4 nanoparticles (Fe NP) with chitosan and to create a model revealing the influence of various factors on the size of iron oxide nanoparticles after coating.