The phrase "after analog" is correct and usable in written English.
It can be used in contexts discussing processes, comparisons, or transitions that occur following an analog method or system.
Example: "The results were significantly improved after analog techniques were applied in the initial phase of the project."
Alternatives: "following analog" or "subsequent to analog".
This work shows that SiPM ToF information can be preserved after analog electro- optical transmission.
It should be noted that traditionally the received data stream when observed via a single receiver after analog beamforming is represented by (5).
In this paper, since the best performance is obtained by the proposed DS-PNC scheme, the DS-PNC scheme is studied to suppress the RSI after analog RF cancellation.
After analog and digital receiver front-ends, the signal contains only the transmissions allocated to that channel, which have well-controlled dynamics under the radio resource management functionalities of the wireless network.
After analog RF cancellation, the received signal at the relay becomes begin{array}rcl@ &&mathbf{y}^{RSI}(t)=mathbf{y}(t -mathbf{H}^{RF}sqrt -mathbf{tH}^{RF}sqrt{t) &&quadqquad;;=mathbf{H}_{MA}mathbf{x}(t)+sqrt{E_{s}}mathbf{s}^{PA}}mathbf{s}^{PA}(t)+mathbf{n}_{R}(t) end{array} (41).
As Figure 2B demonstrates BrdU had been taken up by approximately 50% of the dividing cells by as early as 15 minutes after analog administration and maximum BrdU incorporation into DNA (i.e., 80% 90% BrdU+) in the dividing CL-4 T cells was observed between 15 and 30 minutes after analog administration.
The last block is the digital portion of the receiver where the signal after analog-to-digital conversion is demodulated and synchronization is performed.
At the receiver, after analog-to-digital conversion, the discrete time received signal, denoted with y, is defined as y = ∑ s = 0 P - 1 h CH ( s, ℓ ) x ( ℓ - s ) + η , ℓ ∈ Z, (2).
As described in "PWE instrumentation" section, the electric and magnetic data measured by the WPT and MSC are fed into the EWO and HFA, processed by two CPU boards (CPU 8 and CPU 9) after analog-to-digital conversion, and sent to the satellite bus system as telemetry data.
In addition, molecular alterations also may have the potential to affect cell survival after analogs treatment.
The signal was acquired for processing after analog-to-digital conversion with a detection sensitivity of −104 dB.
