Sentence examples for after a frequency from inspiring English sources

This creates difficulties for the power system to contain the system frequency after a frequency event.

During the initial transient process after a frequency drop event, inertial response plays an essential part in reducing ROCOF and boosting the frequency nadir point.

Secondary response is the minimum increase in active power output which can be sustained between 30 s and 30 min after a frequency event [10].

Fig. 7 Predicted intensity residuals of earthquakes (left panel) and histograms of residuals (right panel) for station pair TKCH01 (surface) and HKD088 after a frequency correction prediction and b scalar correction prediction.

After a frequency domain up-sampling by a factor 2, the signal is filtered by a 2M-point frequency domain filter and an NM-point IFFT is taken on all sub-carriers to generate the transmitted signal.

Fig. 8 Histograms of RMS of residuals for all station pairs separated by less than 10 km after a frequency correction and b scalar correction prediction Fig. 9 Three-dimensional histogram of RMS residuals for all station pairs by less than 10 km after frequency correction and scalar correction.

These descriptive statistics show that even after employing a frequency threshold (≥10) the resulting networks are complex and relatively dense with high link counts.2 Again, the statistics reveal some striking differences between the two institutions, this time in their semantic networks.

Blood specimens were drawn from the blood circuit at the inlet of the centrifugal pump (before) and outlet of the hollow fiber oxygenator (after) at a frequency of three to four times per day.

In brief, event-related time-frequency activity was evaluated in 2 second epochs (0.5 seconds before spindle onset and the 1.5 seconds after) and for a frequency range of 1 30 Hz after band-pass filtering (12 16 Hz), encompassing sigma-band power.

This diagnostic system generated order of tens MHz output signal from an intermediate frequency (IF) amplifier after a radio frequency (RF) mixer.

After transmission over a frequency selective channel, this orthogonality has to be exploited to separate all effective MIMO channels at the receiver.