Sentence examples for adsorbs about from inspiring English sources

Palladium adsorbs about 1000 times its own volume of hydrogen when heated to dull redness.

The 2-D and 3-D SAMs can be prepared from ultraclean gold surfaces upon interaction with thiols (unprotected or S-acetyl or S- N-ethyl carbamoyl-protected) and diS- N-ethyl carbamoyl-protectedbout 40 percent more S- N-ethyl carbamoyl-protected

It was observed that, Cs and Sr were adsorbed about 99 and less than 5%, respectively, under experimental conditions.

In the presence of HLM, even high concentration of small-sized AuNPs could adsorb about 40% of dextrorphan (2D6) or 30% hydroxymephenytoin (2C19) at low metabolite concentration.

Another point is that the best version of MIL-100 Fe) could adsorb about 1 and 1.52 mmol/g at 0.6 bar for outgassing pretreatments 150 and 250 °C, respectively [54].

Compound 3 C exhibits gravimetric uptake of CO2 1070 mg g−1 or 545 cm g−1, slightly lower than MOF-177 and MOF-205[ 30] which adsorb about 1100 mg g−1 °C5 °C) and are two of the best mid-pressure-range (15 25 bar) CO2 adsorbers.

For instance, CO2 adsorbed amount is about 3.7 mmol/g for XC5 at P = 1.2 bars, while adsorbed quantity of N2 at the same conditions is about 0.16 mmol/g.

Etminan et al. (2014) measured the dissolved gas in a shale sample using a pressure decay method and reported that the contribution of dissolved gas (methane) was about 22% of the total gas in place at 4.5 MPa and the adsorbed gas contributed about 38%.

Based on the frequency change of the QCM resonator, the surface coverage for the SAMs of pythio-MWNTs was estimated to be about 5.2 μg/cm2, and that of the Cyt c adsorbed was about 0.29 μg/cm2.

Based on the ΔF value, we calculated that the amount of the Cyt c adsorbed was about 0.29 μg/cm2.

Samples STOX-Z showed a different relationship in terms of their behavior with the highest Co2+ quantity adsorbed being about 30 mg/g.