For C-V measurements, underlap gate structure was adopted (gate length L g of 3, 8, and 16 μm for channel length L of 4, 10, and 20 μm, respectively) to minimize the parasitic capacitance.
We adopted the length of unrestricted gas migration (LUGM) as the main design criterion in this assessment.
The geometrical parameters of practical MWCNTs in our previous experiments [6, 7] were directly adopted with length of l = 5 μm and diameter of D = 50 nm.
Since we obtained the ordered patterns when we adopted arc length instead of angle θ, these rules did not affect our conclusions.
Combining these observations and those from previous reports [ 22- 24], we adopted a length of 500 bp for the putative 5′-untranslated region (5′-UTR) and 500 bp for the 3′-UTR.
We adopted equal lengths for all branches, since estimates of branch lengths for talpids are still very tentative (see [ 44] for a similar procedure).
In session 3, participants walked, on average, 0.13 m.s-1 faster, increased their cadence by 5 steps.min-1, and adopted stride lengths and step times that were around 6% longer and 5% shorter, respectively, than in sessions 1 and 2. Session three was also accompanied by a concomitant decrease in the duration of double support.
These newly added vectors are elongated toward the surface of a virtual sphere to adopt the length of the primary vectors of the octahedron running along the Cartesian axes (Figure 6c).
The unit of length adopted for the practical system was the 108 m (approximately the length of the Earth's quadrant), the unit of time was the second and the unit of mass an unnamed unit equal to 10−11 g and the definitions of electrical units were based on those of the EMU system.
In the pile group setup, pile spacing of eight diameter (8D) was adopted and the length of the piles was so selected as to maintain a length to diameter (L/D) ratio of 20 (Chandrasekaran and Boominadhan 2010).
