The phrase "admissible power" is correct and usable in written English.
It can be used in contexts related to legal, technical, or regulatory discussions where certain powers or authorities are deemed acceptable or permissible.
Example: "The committee reviewed the regulations to determine the admissible power of the board in making financial decisions."
Alternatives: "permissible authority" or "acceptable power".
Once the highest admissible power tolerable by all the resonators was reached, the test was started.
We define the admissible power pricing set, which directly follows from the simultaneous fulfillment of conditions (8a) and (8b), (9).
Proposition 7. A minimum utility requirement chosen under the conditions above is feasible if and only if the optimal power prices calculated in (22a) and (22b) are in the admissible power prices set given in (9), that is,.
We have summarized this simplified search in Algorithm 3, which we describe in the following: To find the solution, we perform a search over the phase split α and the admissible power for the primary transmitter in the first phase P 1 ( 1 ).
In order to solve the nonlinear programming problem of Eq. (7), we need to apply the following conclusion: Fig. 2 The admissible area according to power and QoS constraints.
Yes, even after those references I was convinced this one might be admissible because of its confession of a higher power.
Fig. 2 Admissible area for the transmit power of CU i and D2D pair j. a Without admissible area.
Additionally, in high wind speeds, a pitch control loop is activated to limit the wind power capture below admissible values.
(6 where X is the set of admissible states and is defined by power generation capacity constraints (2) and voltage magnitude constraints (3).
However, some barriers that affect the performance of SPV panels should be considered, as power shortages are not admissible in the cellular network sector.
In Part 1 of this series of papers, six kinematically admissible velocity fields, along with the power terms, were developed for use in upper bound models for arbitrarily shaped dies for axisymmetric extrusion.
