The phrase "adjusting material" is correct and usable in written English.
It can be used in contexts where you are referring to the process of modifying or changing materials for a specific purpose or application.
Example: "The engineer is focused on adjusting material properties to enhance the performance of the product."
Alternatives: "modifying materials" or "altering materials".
In 1980, the reconciliation method was applied to adjust material balancing of mineral processed data [2].
Results of cycling tests of the EUROFER 97 have been thereby used to adjust material parameters needed for an ABAQUS-own combined non-linear isotropic kinematic hardening model.
Fundamental studies revealed numerous synthesis routes which can adjust material characteristics as specific surface area, pore volume, pore size or morphology and elemental composition.
Unlike plasticity-inspired formulations, the proposed model does not postulate damage evolution functions and thus there is no need for additional experimental data to adjust material parameters.
The adjusted material parameters: valence band offset of CdTe and HgTe 620 meV (instead of 570 meV) and the Kane parameter E P 20.8 eV (instead of 18.8 eV), are proposed from the comparison of the experimental and calculation data.
In the year of enactment, SAB 108 required public companies to adjust material accumulations on the balance sheet that may have occurred prior to enactment of SAB 108 after considering all relevant quantitative and qualitative factors.
These TJ provide for a very limited and strongly adjusted material transfer between blood and brain and thus fulfill the barrier function.
The pH adjusted material is pressed to a solid density, e.g. 40% or higher.
Localised plastic deformation in the soft-tip material may be manipulated by adjusting the material properties and geometries of the tip material alongside variables such as; the free blade length, the speed and the properties of the incoming coating.
Gently pull down the saw until the blade almost touches the material and adjust the material side to side, until the blade is positioned to the waste/off cut side of your mark.
