The phrase "adjusted to yield a" is correct and usable in written English.
It can be used in contexts where you are discussing modifications made to something in order to produce a specific result or outcome.
Example: "The formula was adjusted to yield a more accurate prediction of the weather patterns."
Alternatives: "modified to produce a" or "altered to generate a".
The overall N > S normalization was adjusted to yield a few hundred detectable sources per simulation, a compromise aimed at reducing source confusion while limiting the total number of simulations required to obtain good statistics for the characterization.
During the time interval in which the transient baseline shift is recognized, the dynamic noise of the Kalman filter system and the length of the baseline shifts estimation window are adaptively adjusted to yield a robust integration solution.
The relative thickness of the individual sputtered layers is adjusted to yield a low carbon composition in the coating close to the substrate and a stoichiometric composition near the external surface.
is adjusted to yield a nominal PSNR of 45 dB.
After completion of the preparation procedure, the ventilation was adjusted to yield a PaCO2 between 38 and 41 torr (5.0 5.5 kPa).
Any decision, no matter how incorrect, can find conclusive data-driven support merely by searching until some method applied to some dataset is sufficiently adjusted to yield a supportive finding.
To calculate annual utilization measures, the various spans of time were adjusted to yield an annual rate of utilization per category of health service [ 24].
A diode 405 nm and Argon 488 nm lasers (2 and 0.5% output respectively) were used for excitation of the ratiometric probes in the multitrack mode with an HFT 488/405 beam splitter, the signal was detected with 518 550 nm filters, the detector gain was arbitrary adjusted to yield an intensity ratio of the two channels approximating one.
The concentration of the soluble fraction was adjusted to yield polymer peaks with an OD of about 11 mAU in order to compare peaks with equivalent protein concentration despite the fact that a greater amount of Shank3 protein was lost to precipitation after zinc addition.
Both distortion types are perceptually adjusted to yield distinguishable distortion levels.
Before each measurement, the tune and match capacitors were adjusted to yield 50 ohms impedance and the Bo field was optimized by manually adjusting the shims.
