Sentence examples for adjusted to detect the from inspiring English sources

The photo multiplier tube (PMT) setting was adjusted to detect the maximum dynamic range of signal (0 to 65,000).

As the manual IS/OS segmentation was based on slightly different criteria, the IS/OS boundary is adjusted to detect the location of the area with the highest intensity [ 12] rather than the dark-to-bright edge.

A 1-step reverse transcription PCR (RT-PCR) selective for the Morogoro virus RNA polymerase (large [L]) gene was performed as described (6 ); it was based on a pan Old World arenavirus RT-PCR approach (8 ), but primers were adjusted to detect the Morogoro virus (6 ).

Because its sensors are adjusted to detect an impending bike accident, the Hövding is a bicycle-only proposition for now, and skateboarders, motorcyclists and even skiers are out in the cold.

To observe the sandfish in the sand, NMR-imaging, adjusted to detect hydrogen atoms, was employed.

Photomultiplier settings were adjusted to detect JC-1 monomer fluorescence signals on the FL1 detector (green fluorescence, centered at approximately 390 nm) and JC-1 aggregate fluorescence signals on the FL2 detector (red fluorescence, centered at approximately 340 nm).

Second, the instruments can be adjusted to detect up to 5 specific fluorescent emission wavelengths potentially allowing spectral separation of mobility markers, standards and sample oligosaccharides.

Photomultiplier settings were adjusted to detect green fluorescence DePsipher monomer signals, centered at ~390 nm, on the FL1 detector, and red fluorescence DePsipher aggregate fluorescence signals, centered at ~340 nm, on the FL2 detector.

Photomultiplier settings were adjusted to detect green flurorescence of JC-1 monomers on FL-1 detector and the red fluorescence of JC-1 aggregates on the FL2 detector.

Photomultiplier settings were adjusted to detect green fluorescence (λem = 525 nm) of JC-1 monomer using filter 1 (FL1 detector) and the red fluorescence (λem = 590 nm) of JC-1 aggregates using filter 2 (FL2 detector).

If the force pulse along X R was detected, the robot knew it had touched the handle, and started to adjust its position to detect the handle along Y R.