The phrase "adhesive results" is correct and usable in written English.
It can be used in contexts related to outcomes or findings that are sticky or bond-related, often in scientific or technical discussions.
Example: "The experiment yielded adhesive results, demonstrating the effectiveness of the new glue formulation."
Alternatives: "bonding outcomes" or "sticky findings."
Using a brittle adhesive resulted in a negligible maximum load (Pm) improvement with LO.
But over 1.3 wt.% water blending with Reddish Residual Soil and a vinyl type water-soluble adhesive resulted in an unsuitable application of flowing on a substrate.
The use of the epoxy adhesive resulted in improving the strength and stiffness of the composite girders, reducing the stress concentration around the bolt-holes, and increasing the shear strength of the bolt SCs.
The inclusion of 0.75 wt% of MWCNTs in epoxy adhesive resulted in the largest enhancement in the lap shear strength and as the weight percentage of MWCNTs increased from 0.75 wt%, the lap shear strength began to degrade.
In contrast, the commercial CLSE adhesive resulted in 35.6 MPa of bond strength, which was the highest μSBS median value of the study.
Residual buffer found on the tissue surface may have altered the pH of the adhesive, resulting in reduced bulk cohesive properties similar to the effect of buffering the pH of the adhesive precursors.
Regardless of the inherent differences between both adhesives, results obtained show that the global effect of thermal cycles on the load vs. displacement response of EP-GFRP and PUR-GFRP joints was similar.
The pore structure analysis also confirmed that IHSSC-CA has better composite action between NSM CFRP strips and concrete substrate than the other adhesives, resulting in the NSM CFRP specimens made with IHSSC-CA sustaining a greater load.
In studies comparing different resin cements results were opposite or similar about which cement, self-etching or self-adhesive, resulted in the highest tensile bond strength [ 33– 35] or obtained similar results for each cement, be it adhesive, self-etching, or self-adhesive [ 36].
The results show that when using the Composite Peel Test good interface adhesion results either in cohesive failure of the adhesive or intra-laminar failure of the composite, while bad adhesion results in adhesive failure.
