The phrase "adhesive parameters" is correct and usable in written English.
It can be used in contexts related to materials science, engineering, or chemistry, particularly when discussing the characteristics or properties of adhesives.
Example: "The adhesive parameters must be carefully evaluated to ensure optimal bonding between the surfaces."
Alternatives: "adhesive properties" or "adhesive characteristics".
The influence of adhesive parameters on the outcome of cohesive zone finite element simulations is reported.
The crash behaviors can be also affected by both structural and adhesive parameters in the IPC test.
Besides, the effects of adhesive parameters on failure modes and stress distribution are further studied by using the analytical model.
Two adhesive parameters need to be considered: the geometry of the gradation and the material properties of the adhesive at different gradation levels.
Based on the interfacial failure results obtained from experiment and the numerical simulation, the hybrid/inverse identifying procedure time-dependent interfacial parameters is constructed by means of genetic algorithms and the time-dependent interfacial adhesive parameters can then determined.
It is shown that the double cantilever beam model output is dependent primarily on one parameter, whereas the end notch flexure and single lap joint models are dependent on multiple adhesive parameters.
This review article provides a brief idea of adhesives being used in commercially, types of transdermals, their anatomy, fabrication design, assessment of adhesion parameters, regulatory aspects, success and commercial application of adhesive technology in transdermal therapy.
This paper also includes a parametric study undertaken to show the effect of plate geometry, number of spot welds and adhesive joint parameters.
Once the adhesive model parameters obtained, they have been used to virtually study a prototype of the heat exchanger to obtain a suitable solution in terms of thermo-mechanical strength and energetic efficiency.
The effects of side adhesive thickness, material parameters variation and metal material were discussed.
Since mixed-mode fracture occurs along the interface between the steel and the adhesive, the cohesive parameters for the interface were required.
