Sentence examples for adhesive line from inspiring English sources

In both types of corrugated board microscopic examination showed that failure under compression at 50%and9090% RH occurred along the adhesive line as well as by failure of inter-fibre bonds within the components.

According to Artun and Bergland [23], the enamel would be protected if the adhesive line of fracture was located exclusively within the adhesive layer; thus, a thin layer of adhesive would remain attached to the enamel after debonding, covering 100%% of the bracket base's previous location, instead of having a line of fracture at the enamel-adhesive interface) [15].

Three kinds of adhesive lines — cement lines on resorbed alveolar bone, cement lines on resorbed roots, and cemento-dentinal junctions were examined.

In addition, specimens crushed under combined loads show inclined stacking patterns of folds due to the asymmetric location of horizontal plastic hinge lines and the rupture of aluminum cell walls along the adhesive lines.

This study was designed to observe drifting molars of 70-day-old rats by light microscopy, and to elucidate whether there are similar attachment mechanisms at different kinds of adhesive lines in periodontal mineralized tissue of the rat molar region.

They argue that this behavior depends exclusively on the width of the adhesive lines and resembles the behavior in 3D.

To elucidate whether the 3D aspect of the channel walls is the important factor, or only the imposed linear one-dimensional (1D) directionality of cellular movement, we performed migration experiments with microcontact printed adhesive lines.

Analysis of the dynamical change in cell length of cells migrating inside the channels and on adhesive lines was carried out by plotting the cell length over time and calculating its mean value within comparable time frames.

In order to elucidate whether the 3D architecture of the channel walls or only the restriction to 1D motion changed the migration phenotype of the cells, we additionally observed the Panc-1 migration behavior along adhesive lines printed on a non-adhesive surface (Video S4).

Iron the adhesive lining on the other linen fabric; straight stitch both fabrics.

In order to reduce the peel/shear stresses concentration influence in the adhesive layer line, a smart adhesively bonded single-strap joint system was developed to decrease the maximum peel and shear stresses in the adhesive layer by the integrated piezoelectric reinforced composite layers as sensors/actuators.