Sentence examples for adhesive boundary from inspiring English sources

Owing to the increasing agglomeration of the particles, the gravity effect may play an important and even a dominant role, which causes possible sedimentation of the whole agglomeration (the upper part of the agglomeration in Figure 1d is due to the adhesive boundary on the upper wall).

Ca2+-ion-selective membrane based on acrylated urethane polymer was shown to co-polymerize with the CP forming highly adhesive boundary that prevents formation of water layers between the CP and membrane, thus enhancing the stability and life-time of the sensor.

Virtual Work in Structural Analysis, John Wiley & Sons, New York] captures the peel stress as well as the traction free boundary condition at the adhesive edge.

This study provides insights into the mechanics of stress transfer through the adhesive layer, influence of boundary condition at the embedded end of the anchor on stress fields and the design aspects of adhesive anchors.

Effects of face-sheet thickness, core thickness, boundary conditions, adhesive and surface condition of face-sheets on the mechanical response and energy absorption of sandwich panels were discussed.

A gap of 50 mm was provided between the loaded edge of adhesive bonded joint and concrete edge to prevent the edge or boundary effect and to avoid wedge (triangular section) failure in concrete prism (Mazzotti et al. 2008, 2009).

The results also show that in the pre-stressed FRP case, the existence of imperfections leads to larger variations of the stress distributions in the adhesive layer at the boundaries of the imperfections compared with the non-prestressed FRP case.

The boundary between predominantly adhesive and cohesive fracture behavior is at a roundness of 1.5.

The beam and the string are bonded at four points using adhesive material, and therefore the boundary conditions for their equations of motion are coupled, which increases the complexity of the problem.

Fig. 10 Left side chloride and sulfate concentration of poorly adhesive stone material of the boundary wall (box reflects range between samples; maxima and minima as error lines); right side anion concentration of the drilling dust sampled (0 1 cm depth) and H2O under lab conditions (bars show different saturation degree and H2O).

In this study, we examined: (i) the molecular details by which lubricin interacts with type II collagen and how binding is related to boundary lubrication and adhesive interactions; and (ii) whether collagen structure can affect lubricin adsorption and its chondroprotective properties.