The phrase "adhesion value" is correct and usable in written English.
It can be used in contexts related to materials science, engineering, or any field discussing the measurement of adhesion between surfaces.
Example: "The adhesion value of the new adhesive was significantly higher than that of the previous formulation."
Alternatives: "bonding strength" or "adhesive strength".
At the same time point (3 h post infection), the F4ac ETEC was the most adhesive strain, followed by F4ab ETEC with a little bit lower adhesion value (P > 0.05), whereas F18ac ETEC showed the lowest adhesion pattern compared to F4ac ETEC and F4ab ETEC (P = 0.078).
Failure mechanisms are discussed according to examination of response of very dense microstructure and the adhesion value.
The maximum adhesion value of 9.53 N/cm was obtained for the PI/TiO2 1 wt% hybrid film with Ar/N2 plasma treatment.
On the other hand, the energy of adhesion value exhibited by the copolymer BAMO/AMMO/iron oxide is significantly higher than the energy of adhesion values for the iron oxide/PDMS and iron oxide/HDPE systems.
The critical load to the first failure (LC1) was 15 N but the final adhesion value from the film and substrate interface was 120 N (LC2) as function of the coating thinning.
The adhesion coefficient converges to a neighborhood of the maximum adhesion value for the "dry" condition in the initial acceleration phase; after that it suddenly declines to the safe region in the "wet, low or very low" condition adhesion characteristic and converges to the maximum adhesion value of this characteristic function.
As expected, both adhesive strength and work of adhesion values (3.3 ± 0.52 kPa and 4.8 ± 1.0 J/m, respectively) were significantly lower than those for adhesive formulations cured overnight (7.8 ± 1.7 kPa and 15 ± 2.0 J/m, respectively).
Although the performance of the adhesive was significantly improved when applied to tissues buffered at pH 8.0, the adhesive strength and work of adhesion values obtained at pH 8.0 were less than half of those for pH 7.4.
PEG-D4 containing 2 wt % Laponite exhibited lap shear adhesive strength and work of adhesion values (7.9 ± 1.8 kPa and 16.8 ± 3.5 J/m, respectively) that were nearly 2.5-fold higher than those for Laponite-free PEG-D4 (3.5 ± 1.2 kPa and 6.7 ± 2.0 J/m, respectively).
AVJ addition decreased the work of adhesion values.
Consequently, the shear adhesion values decreased and the in vitro drug release constants (k) increased.
