Sentence examples for additive voltage from inspiring English sources

We, therefore, fitted the cost as a linear function of the parameter change in % (multiplicative parameters), or mV (additive voltage parameters).

Each trial was terminated if either the cost function (same as in the fitting procedure; see Methods) exceeded 100 or the parameter was changed 10-fold (multiplicative parameters) or by ±50 mV (additive voltage parameters).

Tris trimethylsilyl) phosphite (TMSPi) is reported as an effective electrolyte additive for high voltage layered lithium nickel cobalt manganese oxide cathode of lithium ion battery.

Triphenyl phosphite (TPPi) was investigated as an electrolyte additive for high-voltage lithium-ion batteries using lithium-rich layered oxide cathode in this paper.

Trimethyl borate (TMB) and triethyl borate (TEB) are used as film-forming electrolyte additives for high voltage Lithium nickel manganese oxide (LNMO) cathode.

Dimethylacetamide (DMAc) and triethyl 2-methoxyethyl phosphonium bis(triethyl 2-methoxyethyl phosphoniumP-TFSI) are investigated as protective additives for high voltage LiNi0.5Mn1.5O4 cathode materials.

The coexistence of graphene additive reduces the initial voltage delay; thus, a prolonged operation voltage is observed with enhanced electronic conductivity, with specific capacity of ~ 462 matg−1 at 5C rate and 661 matg−1Cat 1C rate.

Thus, graphites with small particles and less crystallinity are preferred as conductive additive in positive "high voltage" cathodes in terms of structural integrity.

The disconnection of the thermal fuse, however, did not interrupt the thermal runaway of LIBs without any additives because the battery voltage was too high (ca. 4.9 V).

We have previously demonstrated that N,N′-4,4′-diphenylmethane-bismaleimide (BMI) as an electrolyte additive enhances the high-voltage performance of lithium-ion batteries by electrochemically forming an interface film on cathode surface.

In the presence of these additives, the open-circuit voltage (Voc), fill factor and stability of the cell increased, while the short-circuit photocurrent density decreased compared to those found in their absence.