The phrase "additional shaft" is correct and usable in written English.
It can be used in contexts where you are referring to an extra or supplementary shaft, such as in engineering, mechanics, or construction.
Example: "The design includes an additional shaft to improve the overall efficiency of the machine."
Alternatives: "extra shaft" or "supplementary shaft".
Piping layout design is an area where the basic principles are frequently ignored, resulting in problems such as hydraulic instabilities in the impeller, which translate into additional shaft loading, higher vibration levels, and premature failure of the seal or bearings.
In this layout, an additional shaft on which brake disks are installed is used to transmit the braking torque to the wheelset through a single-stage gearbox.
-This opens the clay for drying, Poke additional shaft holes daily, until the clay loses its stickiness.
The fact that these shafts were labeled "C" and "D" rather than "A" and B" is probably due to the original assumption that these were additional shafts in another mastaba; at some later point G 2302 was distinguished as a separate mastaba, but the shaft designations were not changed to reflect this.
Additional vertical shafts were added to the building to assist in air distribution.
Each additional crack in the shaft requires the knowledge of the changes in two more higher natural frequencies.
It has been shown in the literature that the presence of a crack introduces additional flexibility to the shaft, which reduces its overall stiffness and generates complex orbits and super-harmonic frequency components [15, 16].
Then signals estimated by neural estimators are tested in the electrical drive control structure with additional feedbacks from the estimated shaft torque and the difference between the motor and the load speeds.
The magnetic circuit consists of a multi-pole ring magnet and a pair of ring-shaped soft magnetic parts rotating together with the steering shaft and an additional pair of soft magnetic flux concentration devices which are fixed stationary inside the housing.
One additional patient sustained a femoral shaft fracture from trauma 2 years after surgery that was successfully treated with open reduction and internal fixation without stem revision.
Prosthetic replacement would have been difficult with the deformed ulna with a very thin shaft and has additional risks, including infection and prosthetic loosening.
