The phrase "actuation time" is correct and usable in written English.
It can be used in contexts related to engineering, mechanics, or systems where the timing of an action or response is relevant.
Example: "The actuation time of the valve is critical for maintaining system pressure."
Alternatives: "activation time" or "response time".
Three different design iterations are discussed with progressive improvement in terms of power and actuation time.
The fastest actuation time of three seconds could be, up to now, obtained with the HiPco-material, which is free of amorphous carbon particles.
The experimental results demonstrate the sensor node long lifetime while fulfilling performance requirements, quick detection of a hazardous gas and fast actuation time.
However, the actuation time of an electrothermomechanical microdevice is higher than the actuation times related to electrostatic and piezoelectric actuation principles.
The results indicate that the effective height between OTSG and HX, the HX areas, the volume of CWT, and the isolation valve actuation time are important parameters which are worth being considered seriously in the design of the PRHRS.
This paper suggested a short-cut graphical method to easily size the recycle valves in an anti-surge system by considering the valve characteristics, including the dead time, actuation time, and opening types.
The use of a pre-actuation and a post-actuation time can be easily analyzed as well as the role played by the choice of the desired output function.
In such closed-loop configuration, a better and deeper knowledge regarding the effective sensing-to-actuation time is needed.
A twin boundary velocity of 82.5 m s−1, an actuation response time of 2.8 μs and an actuation acceleration of 1.6 × 106 m s−2 were experimentally observed.
(a) Tensile actuation versus time for 100 actuation cycles of the muscle of Figure 3h.
The electrolytes were 0.1 M BMP.TFSI in propylene carbonate (c) and 0.2 M TBA.PF6 in acetonitrile (d) [1]. Figure 2b shows torsional rotation and tensile actuation versus time for a CNT yarn muscle (with a 40° yarn bias angle for CNT orientation with respect to the yarn axis) that uses the configuration of Figure 2a.
