Sentence examples for acquired thin from inspiring English sources

They extended the possibilities of DWI: scanning time is no more limited (as in breathhold scanning) and image acquisition time is no more confined to a particular phase of the breathing cycle (as in respiratory triggered scanning), images with multiple b-values including high b-values around 1,000 s/mm can be acquired, thin slices can be obtained, and multiple signal averaging is possible.

Three-dimensional sequences can reduce partial volume averaging by acquiring thin, continuous slices through joints [2, 4].

16-DCT offers the possibility to acquire thin slices from the diaphragm to the ankle in less than 40 sec.

Non-echoplanar DWI is capable of acquiring thin slices (as thin as 2 mm) and generating a high resolution matrix, and hence can detect cholesteatoma as small as 2 mm [3, 4, 5].

Nowadays, 3D imaging software for CT can be easily accessed with the personal computer environment [17], and the development of high-quality CT machine such as the multi-detector CT and the cone-beam CT make it possible to acquire thin sliced CT image (being less than 0.5 mm) and to reduce radiation dose with the special low-dose protocols.

(c) Multidetector CT scanner (Sensation 16; Siemens, Erlangen, Germany) that acquires thin-slice images of the whole chest, with 0.5 1 mm thick slices, during a single breathhold was performed.

The CT images must be acquired with thin collimation and the images should be reconstructed with less than one millimeter thickness.

As the lesions started to heal, they became well defined and acquired a thin border of hypoautofluorescence while remaining predominant hyperautofluorescent centrally.

Three-dimensional representations of the porous structure are reconstructed from two-dimensional binary images, after segmentation of digital images acquired from thin plates, commonly used in microscopy.

As the images were acquired in thin areas of the TEM specimen, the kinematical approximation is used, according to which the (200) DF intensity I 200 is proportional to F 200 2, with F 200 as the structure factor of the (200) diffraction that depends on the atomic scattering factors f of the elements in the III-V compound as it is F 200 = 4(f III - f V) [14 16].

ZnO seed layer was prepared by spin coating the sol gel solution (0.1 ml) on a glass substrate (2.5 cm × 2.5 cm) at a rotation speed of 3,000 rpm for 30 s, and the films were then annealed at 350°C for 10 min. The step mentioned above was repeated eight times, and the acquired ZnO thin films were then annealed to 550°C for 2 h to get the final ZnO seed layer.