The phrase "acidic concentration" is correct and usable in written English.
It can be used in contexts related to chemistry or biology, particularly when discussing the concentration of acidic substances in a solution.
Example: "The acidic concentration of the solution was measured to determine its potential effects on the surrounding environment."
Alternatives: "acid concentration" or "concentration of acid".
It is used due to its high acidic concentration which results in high corrosive effect on contacting mediums.
The influence of the electrolyte and the acidic concentration on the redox peak currents of polyaniline were investigated in detail.
In addition, the effect of [H+] variation was observed by varying the acidic concentration in the range of 0.10 0.30 mol dm−3.
This morphology usually forms in high acidic concentration (pH <2.5) and intense monomer concentration (>0.1 mol/L) with a strong oxidant, in which condition the polymer chains grow before the phenazine nucleates organization.
Melamine-bridged PMOs were prepared with high reproducibility by co-condensation using N2,N4,N6-tris 3- triethoxysilyl N2,N4,N6-tris 3- triethoxysilyl N2,N4,N6-tris 3- triethoxysilyllicate in the propyl -1,3,5-triazine-2,4,6-triamine(propyl -1,3,5-triazine-2,4,6-triamine triblock copropyl -1,3,5-triazine-2,4,6-triamine Aldrich) at high acidic concentration.
At the water table downgradient from leachfields, combined Ra concentrations were low (commonly ≤0.019 Bq L−1) when pH was >5.3, indicating sequestration; when pH was ≤5.3 (acidic), concentrations were elevated (maximum, 0.985 Bq L−1 – greater than concentrations in corresponding discharged septic-tank effluents (maximum, 0.243 Bq L−1)), indicating Ra mobilization from leachfield sediments.
Total acidity was used as an indirect measurement of citric acid concentration, the dominant acidic compound in Citrus fruit juice and major responsible of fruit acidity [ 9].
The fuzzy controller was tested for compensating step-change perturbations of propionic acidic flow rates, propionic acid concentration, and buffering conditions.
In this paper, a new numerical model has been developed to predict the condensation rate of sulfuric acid and condensate acidic solution concentration on heat exchanger surfaces.
**Linear regression analysis between acidic methacrylate concentration vs. C = C conversion or bond strength (p < 0.05).
Parameters studied were chemical type (oxidising, alkaline and acidic), reagent concentration, cleaning temperature and soak time.
