The phrase "achieving values of" is correct and usable in written English.
It can be used when discussing the attainment of specific numerical or qualitative metrics in various contexts, such as research, business, or personal goals.
Example: "The project aims at achieving values of over 90% customer satisfaction by the end of the year."
Alternatives: "reaching levels of" or "attaining figures of".
The aluminum foils doubled the thermal conductivity, achieving values of 0.63 W/mK, without significant statistical influence of the metallic configuration inside this material.
As can be seen in Figure 1, the enumeration of S. aureus and P. aeruginosa cells showed that both bacteria extensively colonized both PLLA surfaces, achieving values of 4 Log CFUs/cm2.
Calculations indicate that this device will be capable of achieving values of position sensitivity which are approximately a factor of four or five greater than conventional gamma-ray tracking detectors.
Under optimized conditions, the biosensor response for GSSG sensing was linear from 2.0 up to 35 μmol L−1 with detection and quantification limits achieving values of 0.6 and 2.0 μmol L−1, respectively and sensitivity of 6.24 mA L mol−1.
The PTX growth inhibitory effect was enhanced in Myc cells, achieving values of about 90%.
Following the oral Ca-D3 combination, serum 25OHD3 levels normalised in all subjects with 18 (86%) subjects achieving values of greater than 70 nmol/L.
Expressed as RMS differences, the phase delay analysis achieves values of 3.5 cm (GPS) and 3.3 cm (GLONASS), whereas the SNR analysis achieves higher values of 4.0 cm (GPS) and 4.7 cm (GLONASS).
The concrete mix with 50% RCA and 40% GGBFS achieves values of these properties closer to those of the concrete mix without RCA and GGBFS.
The specific production rates qSurfactin and vol. qSurfactin achieved values of 0.009 g/(g h) and 0.022 g/(L h) [batch, medium B: qSurfactin = 0.006 g/(g h), vol. qSurfactin = 0.017 g/(L h)].
The best polynomial with the same number of optimized coefficients achieved values of r = 0.815, s = 0.196, and F = 1731.
The constraint criteria and the achieved values of the constraining variables by study arm are shown in Table 2 in the Supplementary Appendix.
