Sentence examples for achieves values of from inspiring English sources
The phrase "achieves values of" is correct and usable in written English
It can be used in contexts where you want to describe the attainment of specific numerical or qualitative metrics, often in technical or analytical discussions. Example: "The new algorithm achieves values of accuracy that surpass previous models."
The concrete mix with 50% RCA and 40% GGBFS achieves values of these properties closer to those of the concrete mix without RCA and GGBFS.
Expressed as RMS differences, the phase delay analysis achieves values of 3.5 cm (GPS) and 3.3 cm (GLONASS), whereas the SNR analysis achieves higher values of 4.0 cm (GPS) and 4.7 cm (GLONASS).
Indeed, there is evidence that receptor phosphorylation achieves values of only 10-35% in mammary epithelial cells [ 59], which would be consistent with unequal transphosphorylation by the two kinases in an EGFR homodimer.
The aluminum foils doubled the thermal conductivity, achieving values of 0.63 W/mK, without significant statistical influence of the metallic configuration inside this material.
Calculations indicate that this device will be capable of achieving values of position sensitivity which are approximately a factor of four or five greater than conventional gamma-ray tracking detectors.
As can be seen in Figure 1, the enumeration of S. aureus and P. aeruginosa cells showed that both bacteria extensively colonized both PLLA surfaces, achieving values of 4 Log CFUs/cm2.
Under optimized conditions, the biosensor response for GSSG sensing was linear from 2.0 up to 35 μmol L−1 with detection and quantification limits achieving values of 0.6 and 2.0 μmol L−1, respectively and sensitivity of 6.24 mA L mol−1.
The specific production rates qSurfactin and vol. qSurfactin achieved values of 0.009 g/(g h) and 0.022 g/(L h) [batch, medium B: qSurfactin = 0.006 g/(g h), vol. qSurfactin = 0.017 g/(L h)].
The best polynomial with the same number of optimized coefficients achieved values of r = 0.815, s = 0.196, and F = 1731.
The constraint criteria and the achieved values of the constraining variables by study arm are shown in Table 2 in the Supplementary Appendix.
