The phrase "achieved sufficiently large" is not correct in standard written English.
It can be used when discussing the attainment of a size or scale that meets a certain requirement, but it needs to be rephrased for clarity.
Example: "The project was successful because it achieved a sufficiently large scale to attract investors."
Alternatives: "reached a sufficiently large" or "attained a sufficiently large".
Due to the small diameter of the LED ring, acquisitions had to be done in very close range in order to achieve sufficiently large illumination angles to make the variability of the holograms visible.
To achieve sufficiently large groups for the analysis we have dichotomized several of the factors (Table 2).
However, despite the challenges with registry data, national registry-based studies like ours or international multicenter studies are needed to achieve sufficiently large study populations to examine time trends in the rare late and very late PJIs.
By the Central Limit Theorem and Chebysheff's inequality, this can be achieved, for sufficiently large N and hence m, if j ≤ m / 2 − γ 5 m and J ≥ m / 2 + γ 5 m for some constant γ 5 that depends on p, but not on m.
For both cases, it is shown that a rate-splitting transmission strategy, where part of the message is exchanged on the conferencing channels and then transmitted cooperatively to the base stations, is capacity achieving for sufficiently large conferencing capacity.
Probe sequence motifs with small hybridization affinities are hybridized for up to 30 minutes to achieve a sufficiently large hybridization signal/background ratio.
Problems using the lancet to achieve a sufficiently large blood sample, and applying it correctly to the test strip within the time limit, were encountered.
Due to the low prevalence of cancer in AYAs, recruitment from a number of different clinics is likely to be required in order to achieve a sufficiently large and representative sample.
In contrast to the conventional dielectric mirror fabrication approaches which use vapor deposition, polymer-based PhCs made by self-assembly and IL can achieve a sufficiently large number of layers at very low cost.
The order of magnitude analysis shows the need for further experimental work for both spreading geometries to ensure surface tension forces are negligible, which can be achieved by using sufficiently large oil discharge rates.
