Sentence examples for achieved in the tests from inspiring English sources

With dynamic force balance achieved in the tests, the stable unstable transition of the crack propagation crack is observed and the initiation fracture toughness is calculated from the dynamic peak load.

This indicator is formulated considering (i) the strain state range, (ii) the deformation heterogeneity and (iii) the strain level achieved in the test, based on a continuous evaluation of the strain field up to rupture.

The results indicated that drivers had a robust self-enhancement bias in their self-evaluations regardless of the presence of performance feedback and that they systematically estimated their performance to be higher than they actually achieved in the test.

Very good linearities were, in fact, achieved in the tested calibration ranges with correlation coefficient values >0.99 for all the analytes and accuracies and RSDs calculated for between-run and tested at concentrations of 1, 10, and 80 mg L−1 were ranging from 91.3% to 106.6%, and from 0.5 to 8.9%, respectively.

However, only 30% accuracy was achieved in the test datasets.

With a cut-off of at least 80% sensitivity in the first cohort, 79.6% sensitivity, 66.4% specificity, 14.7% positive predictive value (PPV) and 97.8% negative predictive value of (NPV) for AD were achieved in the test cohort.

Our group previously demonstrated that maximal treadmill exercise test can detect differences in aerobic performance, since that the maximum speed achieved in the test presented a good correlation with the maximum oxygen consumption [ 15].

fuel economy numbers may well be what an accurately performed E.P.A.-cycle test revealed, but they could not be achieved in the Consumer Reports tests.

For the present reaction mechanism and flame conditions, speedup factors of about 10 are achieved in the 1D tests and about five in two dimensions.

Although high iron oxidation rates were obtained at the suboptimal pH of 1.1, the maximum specific growth rate was only one third of the maximum value of 0.066 h−1, achieved in the batch tests.

A simple retraining using a three-fold cross-validation experiment, resulted in only marginal improvement in performance for the Novartis set with AUCs 0.60, 0.64, and 0.69 achieved in the three test sets over the AUCs of 0.58, 0.63, and 0.57 obtained for the default model for the respective sets.