The phrase "achieved from high" is not correct and does not convey a clear meaning in written English.
It may be intended to express something that has been accomplished or obtained from a high source or level, but the wording is awkward and unclear.
Example: "The results were achieved from high standards set by the organization."
Alternatives: "obtained from a high level" or "accomplished from a superior source."
Under proper conditions, multiple ligand receptor interactions, decreased steric hindrance, and increased surface roughness can be achieved from a high density of DNA that is bound to the surface of nanomaterials, resulting in a higher affinity for complementary DNA and other targets.
Toughening of the coating (up to about 25.79 MPa√m) in the shortest immersion time is achieved from the highest level of compressive residual stresses, which make greater tensile efforts necessary to generate a crack.
Case two with results achieved from the high-risk run with a delay of more than 2 years and probability of increase in total cost by 8%.
Education was assessed as highest level achieved from primary, secondary (high school), graduate (bachelor) and postgraduate (master/PhD).
I always preface it with a little disclaimer, asking, "Are you sure you want to deal with all this?" While the high from oil is great, and markedly stronger than any high achieved from vaping or smoking flowers, no one can deny that it is a righteous pain in the ass to deal with.
Her new book, "How to Become a Financial Grownup," offers actionable advice on achieving success from high achievers and influencers.
The best results were achieved from extractions using relatively high volumes (8-10 ml) of xylene and ethanol for the deparaffinization and rehydration steps initiating the extraction protocol.
High call rates (97.5%) and excellent concordance rates were achieved from WGA samples using high-density SNP arrays [ 19, 20].
Excellent adhesion (Lc = 63 N) is also achieved from coatings deposited on high-speed steel with optimized Cr/CrCx/CrC interlayers prepared by high-power impulse magnetron sputtering.
A farmer switches from traditional to IRVs only if utility achieved from the latter is higher than from the former.
