The phrase "achieved for the initial" is not correct and lacks clarity in written English.
It may be intended to refer to something that was accomplished at the beginning of a process or project, but it is incomplete and ambiguous.
Example: "The goals we achieved for the initial phase of the project set a strong foundation for future success."
Alternatives: "accomplished in the initial" or "attained during the initial".
A response rate of 64% was achieved for the initial audit.
Dynamic force equilibrium is successfully achieved for the initial stages of fracture propagation till complete failure of sample.
At a low sulfur loading amount of 0.32 mg cm−2, a high sulfur utilization of 77% can be achieved for the initial discharge capacity of 1288 mAh gS−1, while the specific capacity based on the whole electrode was quite low as 84mAhh gC/S+binder+Al−1 at 0.2 C.
However, our results showed that in all three age groups the interference training resulted in significant and comparable delayed gains, and moreover, that the within-session performance gains for the interference sequence (B) were not significantly (negatively) correlated with the delayed gains achieved for the initial sequence (A) in both the 17 and 12-year-olds.
Return for follow-up may therefore serve as a more accurate index of parental commitment than the coverage achieved for the initial screening.
Therefore, the CLGOS can be achieved for any initial values.
Numerical simulations are used to show the following results: (i) the synchronization precision in MC DPLLs networks; (ii) the existence of synchronous states for the network does not guarantee its achievement and (iii) different synchronous states may be achieved for different initial conditions.
Inhibition of the treated by 15 μM RB E. coli cells was expressed by a 4 4.7 log10 decrease in CFU compared to the untreated samples (P value = 0.041), (Table 1), and the highest eradication rate was achieved for an initial bacterial concentration of 10 CFU mL−1 treated by 15 μM RB, where the remaining E. coli concentration dropped to only 20 CFU mL−1.
The best performance 59% conversion was achieved for an initial 500 ppm after 240 reaction minutes.
Although the collision rate is suppressed as the temperature T is reduced below the Fermi temperature TF, we find that values of T/TF蠐1 can be achieved for suitable initial conditions.
In case of specific cycle period of 4 hr (aerobic) and 4 hr (anoxic), it was observed that at the end of 8 hr react period of reaction, 90.12% nitrification could achieved for an initial NH4+-N was approximately 87.52 mg/L as Fongsatitkul et al. [ 40] obtained maximum 93% removal efficiency of soluble nitrogen for treatment of abattoir wastewater which was slightly higher than our result.
