It is also reported that the unweighted recognition performances achieved for valence mode is highly lower than the arousal.
Then a modified maximum tangential stress criterion was used and hence, significantly improved estimates were achieved for mixed mode fracture resistance of the tested graphite materials.
Notably, the highest B value achieved for the DET mode (81%) was much higher than that for the MET mode (about 57%).
Good camouflage performance can be achieved for TM wave mode along certain directions.
Also, up to 23.2% power reduction is achieved for iso-delay mode.
By optimizing the device's structure parameters in detail, polarization independent excess loss of −0.32dB is obtained, and negligible output uniformities of −0.02dB and −0.03dB could be achieved for the TE and TM mode, respectively.
Its architecture is always designed based on the cubic-configuration Stewart platform, whose six flexible modes generally have different natural frequencies resulting in multiple resonances at various frequencies such that a uniform capability of vibration isolation cannot be achieved for the six flexible modes.
The highest efficiency of energy transfer achieved for the first vibrational mode of the cantilever was about 2 millipercent for the maximum laser pulse energy used, 1.5 J, the signal to noise ratio then being about 40 dB.
This paper presents a theoretical analysis along with simulations to show that increased robustness can be achieved for discrete time sliding mode control systems by choosing the sliding variable, or the output, to be of relative degree two instead of relative degree one.
It is found that by using aligned mesh with the fiber direction for each ply, a good correlation with experimental results can be achieved for both strengths and failure modes of the laminates.
