Sentence examples for achieve a friction from inspiring English sources

It is suggested that such information can be used in designing of compound formulation to achieve a friction material with good frictional and processing properties.

In order to achieve a friction force which exhibits a rather large, 2-fold, anisotropy, the table is covered with a sheet of corrugated cardboard (wavelength 3.5 mm, amplitude 1 mm) whereas the lower surface of the slider is covered with a disk of lightweight felt (thickness about 1 mm).

Conical connections were developed to achieve a friction-based fit of the implant components [ 16– 20].

The results obtained show that addition of VN to hard coatings has high potential to achieve a low friction effect due to the formation and melting of a V2O5 containing oxide, in addition to its conversion into easily shearable lower-oxidized vanadium phases.

Here, a poly styrene-co-butyl methacrylate) poly styrene-co-butyled on poly styrene-co-butylgh static friction at the interface between a coating and e.g. a wood pallet.

70 kilometers (43 mi) is the altitude at which Kerbin's atmosphere ends, if your apoapsis is under this altitude, you will not be able to achieve a stable orbit as friction from the atmosphere will cause your craft to slow down and fall back to the rocky ground.

The coupling of the MD calculation for the macromolecule part and the LB modeling for the solvent is achieved via a friction ansatz, in which they assumed the force exerted by the fluid on one monomer was proportional to the difference between the monomer velocity and the fluid velocity at the monomer's position.

In this work we present the results of a series of experiments aimed at investigating the effect of the incorporation of carbon nanoparticles (nC) on the tribological properties of CrN, in order in particular to check the possibility of achieving a lower dry friction coefficient.

Here, we report a unique tribological behavior of nonhydrogenated a-C film when slides against the steel counter-parts in polydimethylsiloxane (PDMS), where the a-C film is severely fractured at the onset of sliding, but achieves a very low steady friction coefficient which is only about 50% of the one obtained in the poly-alpha-olefin (PAO).

In a ball-on-disc wear test, an alumina ceramic body sliding against a silicon nitride ceramic body in water achieved an ultra-low friction coefficient (ULFC) of 0.004.

In an effort to achieve lower friction on CDC films, we developed and used a special hydrogenation process that was proven to be very effective in lowering friction of CDC films produced on SiC substrates.