Sentence examples for achieve a delay from inspiring English sources

Today, almost any industrialized country can produce a nuclear weapon in four to five years — hence any successful strike would achieve a delay of only a few years.

For our experiment, we were able to achieve a delay on the order of a single sample, thanks to a feedback control sampling rate of 44.1 kHz.

As it is shown in Figure 5, for all the prioritization schemes achieve a delay lower than the maximum ( milliseconds); in fact, the 99th percentile measured over is 25 milliseconds for TSPS and PFS, and 15 milliseconds for the.

The reason for KAM to have higher delay violations than CHAU is due to the fact that KAM only tries to assign a higher rate ancestor code and tWhileanytime codes assigned to sibling codes might block each other.

However, as the network size increases to 50 vehicles, on average only 40% of the beacons achieve a delay less than 100 ms for the typical transmission frequency of 1 to 10 Hz.Equally important is the reliability, which is often characterized by the PDR performance metric, illustrated in Figure 5.

The term in (11) means the minimum number of bits that should be transmitted in the actual frame in order to achieve a delay for each packet, where is a guard time. is a normalization factor which is the maximum number of bits that could be transmitted within a frame using the highest MCS.

Ways must be found to take care of interconnections at an early design stage, achieving a delay aware floor planning.

Targeting a Xilinx Kintex-7 FPGA device, we report on real hardware implementations of our designs, the fastest of which achieves a delay of just 7.97 μs for computing one scalar multiplication on a 1-core design.

Existing AQM schemes achieve a "low delay" and "high utilization" by responding early to congestion without considering the exact relationship between delay and utilization.

In terms of delay, as shown in Fig. 4b, policies that forward newly generated bundles or recently transmitted bundles achieve a low delay.

In order to achieve a specific delay performance, the cost constant V is replaced by a dynamic cost index V t), which is updated based on a "Total queue length" Ψ ( t ) = ∑ n = 1 N Q n ( t ), as follows, V ( t ) = V ( t − 1 ) + δ ( Ψ target − Ψ ( t ) ), (11).