Sentence examples for accumulated thermal from inspiring English sources

The weights of individual kernels from upper, middle, and lower spikelets of the main stem spike were fitted into nonlinear cumulative logistic curves as a function of accumulated thermal units using SAS proc NLIN.

The heating rate of outlet syngas, strata floor and roof was relatively slow as the main purpose of this phase was to preheat the coal seam and accumulated thermal energy, in preparation for latter phase (Stanczyk et al. 2011; Krzysztof et al. 2012).

It was determined that in the heat storage tanks with internal heat source fitted at the bottom of the tank the residual water temperature is higher, and the amount of accumulated thermal energy is lower than in the tanks with external heat source.

Adding accumulated thermal stress in a linear model against either absolute change in coral cover, proportional change in cover or SARCC did not result in a significant coefficient.

Knowledge of the relationship between accumulated thermal units and developmental stages of Chinook salmon embryos can be used to determine the approximate date of egg fertilization in natural redds, thus providing insight into oviposition timing of wild salmonids.

Although coral bleaching was not severe in the Bahamas [14] (also confirmed by in situ observations at the study sites, Mumby pers. obs)., we calculated the accumulated thermal stress in 2005 above that of the climatological maximum monthly mean [25 ]

It can also accumulate thermal energy during a series of clear sunny days without overheating the slab surface or the living space.

An experimental investigation was carried out to improve the energy efficiency of a household refrigerator by integrating a Phase Change Material (PCM) to accumulate thermal energy and stabilize the temperature in the refrigerator compartment.

However, depending on the temperature time evolution, tissue regions that have seen varying temperatures between 43°C and 57°C (for the typical procedure durations between 10 and 30 min) may also accumulate enough thermal dose to become thermally coagulated.

It also prevents accumulating of thermal energy by the adhesive material, which otherwise would soften and immerse the particles, being equivalent to the loss of the evidence material.

The study indicates that the area passive neutron dosimeter was able to detect dose rates as low as 7 and 182nSvh−1 from accumulated dose for thermal and fast neutrons, respectively, which were not possible to detect with the available active neutron dosimeters.