The phrase "acceptable tolerance for" is correct and usable in written English.
It can be used when discussing the degree of variation or allowance that is considered acceptable in a particular context, such as quality control or standards.
Example: "In our manufacturing process, we have established an acceptable tolerance for the dimensions of the parts produced."
Alternatives: "permissible margin for" or "allowable variation in".
And through arranging reference test sensors, 15 cm up and down from the central primary test sensors, the test errors due to location deviation increase to −8.14% and −9.60% respectively, which basically meets the accuracy requirement and thereby demonstrates the SHB-HFM has an acceptable tolerance for the in-situ operation.
The tolerances were established using both surgical norms and a clinical perspective, since acceptable tolerance for tibial rotational alignment and rotational mismatch between the components are not well-defined [ 10, 15, 16, 18, 20, 31- 34].
A prior acceptable tolerance for the difference between eGFR and sGFR was defined as twice the limit for CKD stages, which is 60 mL/min/1.73 m. 8 The accuracy of GFR estimates was determined as the percentage of results deviating less than 15%, 30%, and 50% from the sGFR.
Surviving features found in both samples are evaluated such that where x i is the C/C mixing ratio of the ith sample, r i is intensity ratio (I12C/ I13C) of the ith sample, and e (ratio_tol) sets the acceptable tolerance for the intensity ratio relative to the mixing ratio.
The objective of this investigation is: (1) establish correlations coefficients and acceptable tolerances for standard manufacturer samples of concrete admixtures, (2) verify the established acceptance criteria by testing job samples, and (3) provide interpretations of IR scans of concrete admixtures including the factors that may influence them.
The optimized MMDG structure shows acceptable tolerances for grating fabrication.
Also, little is known about how to determine acceptable tolerances for project performance indicators (Willems and Vanhoucke 2015).
FDA has responded to this information by disallowing carbendazim use on food crops in the US and has no acceptable tolerances for this fungicide on imports such as orange juice.
In the method the different combinations of retention time and accurate masses and the acceptable tolerances for these data and the SigmaFit value are defined.
This is an acceptable tolerance of experimental measurements. .
We employed a qualifier transition and incorporated an acceptable tolerance limit for the acceptance of data to decrease the possibility of misidentification of the 8-oxodG and of the contribution of any underlying peak.
