Sentence examples for acceptable power level. from inspiring English sources

A possibility of achieving high thermal efficiency at acceptable power level is shown.

For the smallest effect size considered, 0.05, even 100 clusters per arm is not sufficient to obtain anywhere near an acceptable power level for ICCs above about 0.02.

Re-formulation of the problem in terms of minimum detectable difference can thus be used to compare the difference which is statistically detectable (at acceptable power levels) to that which is clinically, or managerially, important.

The optical powers we use in this study (7 mW integrated for the FTIR broadband source and around 5 mW average for the QC laser), as well as the path length of the liquid cell (100 μm), are kept in accordance with acceptable power levels and expected propagation path lengths in human skin.

A simulation-based evaluation, considering node density, node mobility, traffic load and flow number, shows that our algorithm improves the average end-to-end latency and throughput with acceptable power consumption level.

The two-stage procedure might be considered incorrect from a formal perspective; nevertheless, in the investigated examples, this procedure seemed to satisfactorily maintain the nominal significance level and had acceptable power properties.

The receiver will calculate its tolerable power level and send acceptable-power-to-send (APTS) back to the sender.

While our findings suggest a single general practice cannot feasibly measure its rate of harm with acceptable precision or adequate power, we provided many CRR scenarios that would yield harm rate estimates with adequate precision and acceptable power if implemented at national or regional level and a formula to test any other proposed CRR adaptations.

The optimal mechanical properties and an acceptable ferrite/austenite ratio throughout the weld regions correspond to the power level.

The main idea of these power control schemes is to use a maximum possible power level for transmitting RTS/CTS and the lowest acceptable power for sending DATA/ACK.

As the simulation results show, we found that when we adjusted the power level to 2 or 3, we could get acceptable performance.