Sentence examples for acceptable bond from inspiring English sources

A significantly lower and clinically acceptable bond failure rate was demonstrated with Transbond Plus SEP after pumice prophylaxis.

Based on the numerical analysis of the test results, new criteria for acceptable bond performance of GFRP/steel wire composite rebars to concrete were developed.

Mean values of shear strength were similar to previous studies [40, 41] and were within the clinically acceptable bond strength range.

In clinical limitations where light curing from the same side of the bracket is not possible, doubling the curing time and increasing the light intensity during trans-illumination are recommended for achieving acceptable bond strengths.

This leads to the deduction that doubling the light curing time and increasing the light intensity to 800 mW/cm2[2] have to be done simultaneously in order to achieve acceptable bond strength values when using trans-illumination technique.

In clinical limitations where light curing from the same side of the bracket is not possible, doubling the curing time and increasing the light intensity to 800 mW/cm2 during trans-illumination with the LED light-curing unit can be done for attaining acceptable bond strength with minimum risk of overheat to the pulpal tissue.

The key issue is to choose a compaction temperature which melts the minimum amount of the original oriented elements whilst achieving acceptable bonding within the compacted structure.

The dataset molecules were docked into the active site of Plk1, which shows acceptable hydrogen bond interactions with residues Cys133, Asp194, Glu131, Lys82 and Glu140 and also shows further hydrogen bond interactions with hydrophobic residues Cys67, Leu59 and Arg136.

Implicit in the formation of an acceptable adhesive bond is the ability of the adhesive to wet and spread on the adherends being joined.

Interest rates have moved up in a no-confidence vote; higher growth, increased inflation and fiscal imprudence are not acceptable to bond investors.

Microstructural analysis of the non-fibrous geopolymer control sample revealed a good degree of geopolymerization and the fibers yielded an acceptable interfacial bonding with the geopolymeric binder.