The phrase "absorption of control" is correct and usable in written English.
It can be used in contexts discussing the process of taking in or adopting control over a situation, system, or entity.
Example: "The absorption of control by the new management team has led to significant changes in company policy."
Alternatives: "acquisition of control" or "taking over control".
where A0 is absorption of control, AS is absorption of tested extract solution.
From these results, it can be seen that the initial surface absorption of control as well as the MK concretes show values much <3%%, the limit specified for "good" concrete by CEB (CEB-FIP 1989).
The scavenging activity was estimated based on the percentage of ABTS radicals scavenged by the following formula: % scavenging = (A0 – AS / A0) × 100, Where A0 is absorption of control, AS is absorption of tested extract solution.
AlamarBlue (20 ul, BioSource International) was added at 24 hr and at 48 hr the extent of its reduction was determined by comparing absorption of control and test culture media at 570 nm and 600 nm.
Ethanol absorption of control and ethanol-reared adult flies was measured during exposure to vaporized ethanol at 0, 5, 15 and 30 minutes (110 40, vaporized ethanol: humidified air) (Moore et al., 1998).
We also discuss mesh refinement to model "the skin effect" when depleting the absorption materials of control rods.
With increasing strain rates, the peak strain and energy absorption capacity of control and sulfate attacked concrete tend to increase, but they are greatly decreased by disruptive expansion and chemical deterioration induced by sulfate attack.
The survival fraction was calculated from the following equation: (1) Survival = 2 - t delay t doublingtime in which tdoubling time is the time period required for a quantity of cells to double and tdelay is the time period to reach specific absorption value of control versus irradiated cells.
It is worth noting that specimens (WSB) and (ESB) reached about 41% and 222 % of the energy absorption of the control beams respectively.
Besides, transitions between |+,N +〉 and |-, (N + 1 -〉 indicateprobe amplification (the leftmost solid line in Figure 2b) becauseof a three-photon process, involving simultaneous absorption of two control photons andemission of a photon at frequency ω c -ω n.
The results of the cold water absorption of the control and biosolids-amended bricks showed that the addition of WTP biosolids caused a gradual increase in the cold water absorption for all heating rates.
