Sentence examples for absorber about from inspiring English sources

The well-absorbing bandwidth of iron absorber (about 2.1 μm) exceeds the bandwidth of tungsten absorber (about 1.8 μm).

The membrane absorber contributed about 39% to total investment cost.

The absorption efficiency and ultra-narrow band of the absorber are about 98%% and 0.5 nm, respectively.

Absorber absorbance.

To identify these muons and measure their momenta, the interaction region of the CMS detector is surrounded with enough absorber material, equivalent to about 2 m of iron, to stop all the particles produced except muons and neutrinos.

The Kaydon Corporation, a maker of bearings, filtration products and seals, said yesterday that it acquired ACE Controls Inc. and ACE Controls International Inc., makers of industrial shock absorbers and valves, for about $70 million.

Every commercial process has unique requirements and an example of requirements outlined for an amine gas treatment plant includes: the temperature of the lean amine solution entering the absorber should be about 100F higher than the inlet gas temperature to prevent hydrocarbon condensation and subsequent foaming.

The energy spectrum of X-ray photons after passage through an absorber contains information about its elemental composition.

Pure H2S gas (99.9%) was sparged in the absorber unit for about 35 45 min. In the absorber unit, Fe3+ malic acid chelate solution oxidized H2S gas to elemental sulfur and simultaneously active ferric chelate was reduced to inactive ferrous chelate (reaction 2).

Since our theoretical results indicate that the PA RF signals are significantly affected by the size and concentration of the absorbing structures, it is then reasonable to expect that normalizing the PA RF power spectra by the transducer frequency response can provide information about absorber properties such as size.

Based on a comprehensive review of selective solar absorbers [13], typical spectrally averaged selective solar absorber emissivities ε ̄ are about 0.05 at temperatures of approximately 373 K. Assuming δ = 0.05 as well, this implies a maximum system efficiency of 10.5% (T = 720 K, η t = 0.6937, η p = 0.1510, A E /A s = 0.75), as illustrated in Figure 3a.