The phrase "about the planar" is not standard in written English and may be unclear without context.
It could be used in discussions related to geometry, design, or engineering when referring to planar surfaces or concepts.
Example: "The research paper focuses on the properties about the planar structures in modern architecture."
Alternatives: "regarding the planar" or "concerning the planar".
The planar collector collected about 90% of the dew at the grass cover while the pyramid collector collected about 1.20% of the grass cover.
The strength tested along the planar direction is about twice that tested through the thickness direction.
Then small vibrations about the prebuckled (planar) states are studied.
It is found that a band gap about 0.4 eV occurs in the planar junction.
The axial rate of Ge NWs is first about seven times higher than the planar rate, and then it continuously decreases on increasing the evaporated fluence until it comes back to the planar value.
Moreover, after the conditions for the catalyzed growth are reached, the axial growth occurs in a limited range of evaporated fluences (from 1.75 to 2.50 × 1018 cm-2), but it is very efficient being about seven times higher than the planar rate.
However, in terms of the 5 nm Al2O3, a capacitance density as large as 92 fF/μm2 was achieved at zero voltage, which is about ten times that of the planar capacitor with 5 nm of Al2O3, and it is around eight times that (11 fF/μm2) of the 20 nm Al2O3.
The planar reservoir expanded about 10 cm before the eruption on April 28 , 2012 but shrank 40 cm after the eruption (as of July 2012).
Both the n- and p-type FinFET devices, as shown in Figure 3a,c, have comparable magnitudes of σ/μ which are smaller than that of the planar MOSFET devices (about 50% reduction), as shown in Figure 3b,d.
The ratio of the local stretch rate at the flame edge and the extinction stretch rate for a single planar flame with the same composition was slightly smaller than unity, though the extinction stretch rate for the planar flame was about half of that for the twin planar flame due to large heat conduction to the opposing inert gas.
