The phrase "a voltage increase" is correct and usable in written English.
It can be used in contexts related to electrical engineering, physics, or discussions about electrical systems where changes in voltage are relevant.
Example: "The circuit experienced a voltage increase, which caused the lights to brighten unexpectedly."
Alternatives: "an increase in voltage" or "a rise in voltage".
Results show a voltage increase of about 10 mV between new and damaged configuration simulations.
The difference of the voltage between the ISFET device and control device without enzymes showed a voltage increase along with the enzymatic reaction of P450 monooxygenases, and this voltage increase in the device was inhibited by addition of MnCl2, an inhibitor of P450 monooxygenase.
There appears to be a lag between the two major plateaus observed in the galvanostatic cycling and the two-phase reaction regions emerging from the refinements, a voltage increase from 4.82 to 4.89 V being observed before the LiCoPO4 phase has fully converted to Li x CoPO4.
Illumination by white LED light at 200 μmol m−2 s−1 resulted in a reproducible voltage increase at a rate of 21.7 ± 4.7 mV h−1 with Δ Vlight-dark = 5.2 ± 0.6 mV.
Figure 3(a) shows charge-discharge curves of the cell at a constant current density of 0.1C at 30 °C (C-rate is defined as the current to discharge the theoretical capacity in 1 hour: 1C) The Na2V3O7 electrode exhibited a reversible capacity of about 90 mAh g−1, and a sharp voltage increase followed when a voltage cutoff condition of 3.5 V vs. Li+/Li was reached.
The emission was shown to be remarkably stable with a current of approximately 750 μA cm−2 maintained for 15 h with a net voltage increase of only 1.8%.
At high pumping speed or low current, a target voltage increase is noticed before the critical point.
The cell voltage response to dynamic feeding of methanol revealed that a significant voltage increase can be obtained from dynamic changes in methanol feed concentration.
The subsequent charge curve displayed a continuous voltage increase with progressing delithiation, resulting in large voltage gaps during the discharge charge cycle.
The first dimension separation or isoelectric focusing (IEF) was performed by the Ettan IPGphor III IEF System (GE Healthcare, Little Chalfont, UK) at 20 °C using a stepwise voltage increase to reach 9000 Vh.
Isoelectric focusing was performed at 20°C using the following 3-phase run parameters (upper limits for current and power were set to 2 mA and 2 W, respectively): phase 1, 300 V for 1 volt-hour (Vh); phase 2, a linear voltage increase to 3500 V over 2900 Vh; phase 3, constant 3500 V for 9.1 kVh (pH4-7) or 6.1 kVh (pH6-11).
