The phrase "a uniform cross section" is correct and usable in written English.
It can be used in contexts such as engineering, physics, or materials science to describe an object or material that has the same shape and size throughout its length or area.
Example: "The beam was designed with a uniform cross section to ensure consistent strength and stability."
Alternatives: "an even cross section" or "a consistent cross section".
The structural beams with a uniform cross section of hat-shape were manufactured through a high-cycle compression molding technique, by using randomly oriented chopped thermoplastic composites.
The problem of the lateral bending vibrations of a uniform cross section Euler-Bernoulli beam has been treated by many investigators.
For example, the vibrations of a guy wire of a uniform cross section and composed of N parts of different densities can be set up as a multi-point boundary value problem [3].
Multipoint boundary value problem (BVP) arise in a variety of different areas of applied mathematics and physics, such as the vibrations of a guy wire of a uniform cross section and composed of parts of different densities can be set up as a multipoint boundary value problem [7].
The images taken (Fig. 4 c-h)) while focusing at different position near the interface (Fig. 4 c-h clearly confirm that the radiation pattern is a uniform cross section of the beam whilethe focusingate is in the air (Fig. 4(g-h)) while, when it is in the bulk of the crystal (Fig. 4(c-e)), it is ring shapedifferenttensity concentrated on the edges and riposition the middle.
A finite element model of a uniform cross sectioned cantilever was chosen to provide data for analysis.
The column has a variable cross-section whereas the girder has a uniform cross-section.
Previous literature typically assumes a uniform cross-section and axial excitation due to the wavelength of the field modulation being much larger than the cavity.
Each limb body is modeled as a spatial beam with a uniform cross-section constrained by two sets of lumped springs.
If the chamber has a uniform cross-section, heat will be lost along the direction of flow and eventually the far-end of the wafer will be cooler.
A geometric design method is then presented for the fabrication of any folded structure with a uniform cross-section specified as a non-intersecting polygonal chain.
