Sentence examples similar to a typical bis from inspiring English sources

Low-angle XRD analysis showed that the coating has a nanoscale multilayer (superlattice) structure with a typical bi-layer thickness of 4 nm.

CrAlYN/CrN coatings utilising nanoscale multilayer structure with a typical bi-layer thickness of 4.2 nm have been deposited on light-weight Ti 45Al 8Nb alloys known as γ-TiAl.

GPS-R is a typical bi-static radar technology with transmitters located on GPS satellites and receivers mounted on a LEO satellite, an aircraft, or a structure on the ground.

Also it is shown that the magnetic field non-linearity or the image distortion of a typical bi-planar gradient coil can be adequately parameterized using a finite Taylor series expansion based on its design parameters.

This reaction also contributes to sustainable incorporation of S into CMTS to a considerable extent and formation of notable large grains; whereas, it leads to the formation of a typical bi-layer microstructure containing large grains (500 800 nm) on the top and fine grains at the bottom.

The overall structure adopts a typical bi-lobal kinase architecture.

Interestingly, Hay and Wydrzynski observed a 260 mV decrease in reduction potential when they substituted the native Met ligand in cyt b562 with His, yielding a typical bis-His cyt. This decrease is greater than ∼150 mV, and the authors attribute it to destabilization of the fold and increased solvent exposure, which is known to significantly lower the potential (vide infra).

- Why the expiratory bursts recorded from L1 do not show a typical bi-phasic discharge pattern as demonstrated by Janczewski et al (2002)?

The plot of the calculated G/C skew [ G-C /(G+C)] indicated a typical bi-directional replication mechanism of the C. variabile chromosome.

Mucosal (lamina propria) eosinophils of the stomach, duodenum, and rectosigmoid areas were further quantified by the primary investigator (J.A.B .. Eosinophils were identified by the characteristic prominent eosinophilic cytoplasmic granules and a typical bi-lobed nucleus.

In a typical procedure, Bi(NO3 3 · 5H2O (2 mmol) was added to 20 mL 1 M HNO3 to form a clear solution under stirring for 30 min at room temperature.