The phrase "a type of adhesive" is correct and usable in written English.
It can be used when describing a specific category or classification of adhesive materials.
Example: "Super glue is a type of adhesive that bonds quickly and strongly to various surfaces."
Alternatives: "a category of glue" or "a form of bonding agent."
Our body, canopy, fairings, and many other small components are all made of carbon fiber composites, which combine the strength and flexibility of carbon fiber with the stiffness of hardened epoxy (a type of adhesive).
If you use fabric to cover your folders, make sure you use a type of adhesive that won't bleed through the fabric and that will hold the fabric onto the folder, such as a spray adhesive, instead of super glue.[25].
Cross a gecko with a mussel and what comes out is a new type of adhesive tape that can repeatedly stick and restick, even underwater.
The present study is concerned with the failure analysis of a special type of adhesive corner joint, which is essentially a rectangular cantilever bonded to a support.
In one study, for instance clear duct tape was not significantly more effective than a moleskin bandage.[4] The speculation is that clear duct tape uses a different type of adhesive than grey duct tape and the difference accounts for the lack of effectiveness.
Studies of the solid bridge force, which is an important type of adhesive force, are scarce at present.
A solvent-based type of adhesive has been selected for this study since its higher fluidity should enable producing a higher-quality joint.
It was also shown that the geometry of the L-parts and the type of adhesive have a direct influence on the joint strength.
But if a dealer or the police have reason to suspect a piece of scrap might be stolen, then SmartWater's laboratory can tell them who bought the batch of adhesive in question.Selectamark's technology also uses microdots, though instead of celluloid it employs polyester or a nickel-based alloy, depending on the type of adhesive involved.
The exact fracture path observed was a function of (i) the type of composite substrate, (ii) the type of adhesive, and (iii) the mode of loading employed.
