The phrase "a transparent end" is correct and usable in written English.
It can be used in contexts where clarity or openness about the conclusion of a process or situation is being discussed.
Example: "The project was designed with a transparent end, ensuring that all stakeholders understood the final outcomes and implications."
Alternatives: "a clear conclusion" or "an open ending".
The paper by Chi-Huang Shih et al. introduces a transparent loss recovery scheme based on a transparent end-to-end QoS mechanism and an instantaneous frame-level FEC allocation technique, which provides near optimal performance with low delay.
In this article, the optimization design steps of a transparent flow field unit, which is composed of a graphite pierced plate and a hollow transparent end plate, are introduced.
Furthermore, a hollow transparent end plate is designed, i.e., a polycarbonate frame of 25 mm thick is assembled between two polycarbonate sheets of 6 mm thick to form a hollow transparent end plate.
As with other kinds of smart fluids, the effect is not new, but was seen as a curiosity until recently.Two non-mixing fluids are placed in a short tube with transparent end caps.
From research development to scholarly output, creating a more transparent end-to-end process allows unfettered sharing, inclusion and collaboration as a continuum in scientific research and discovery.
One of the main goals of the Groningen Protocol was to enable a more transparent end-of-life decision-making for newborns and to provide guidance on how to properly report these decisions.
No fog is formed on the inner surface of the hollow transparent end plate when the new design is employed in a transparent single cell.
Glycerol, which is firstly heated to a temperature three degrees higher than the cell temperature, is pumped into the glycerol cavity of the hollow transparent end plate.
The constant strain-rate tests were conducted with transparent end pieces attached firmly to the upper and lower ends of the specimens.
In this research, the charge trajectory measured in a laboratory mill (model mill) with the diameter of 100 cm and length of 21.5 cm with the transparent end was compared with that of the GMT.
