The peak torque value for extension was recorded.
First to the specific torque value for each bolt, then 1/8 or 1/4 turn past that for each bolt.
The actuator inertia and static friction torque values for the prototype were only 0.6% and 4%, respectively, of the values found for a comparable actuator from an industrial robot.
Fig. 8 Comparing African and Caucasian tip and torque values for the upper jaw Fig. 9 Comparing African and Caucasian tip and torque values for the lower jaw.
The software then provided the tip and torque values for each tooth on the final setup, reading the FACC values with respect to the occlusal plane.
In addition, significantly lower deviations of torque values for beam-type wrenches were reported than for coil and toggle-style wrenches [18].
The average method errors of the torque values for all teeth were 1.2° and 1.5° for the mandible and the maxilla, respectively, while the errors of tip values were 2.0° and 1.8° for the mandible and the maxilla, respectively.
The authors who proposed this method reported that the average method errors of the torque values for all teeth were 1.2° and 1.5° for the mandible and the maxilla, respectively [21].
The apparent torque values for the present mutants are all ∼20 pN·nm, similar to the torque of γ-ΔC21.
Torque values for each contraction were calculated and peak tetanic torque values (the highest obtained torque value within any of the below mentioned four intervals) were recorded.
We found similar torque values for adduction also with no major difference between primary and revision cases.
